Table of Contents
Advertisement
Display
Setting
Signal tones
Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
Automatic switch-off of the cooking zones.
Duration of the timer end signal tone
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob (see rating plate). If the function is active
and the hob has reached the set power limit,
is displayed and you cannot select a higher
power level.
Cookware test
You can use this function to test the quality
of the cookware.
Restoring factory settings
Factory setting
1
16.2 To go to the basic settings
Requirement: The hob must be switched off.
To switch on the hob, touch
1.
Within the next 10 seconds, press and hold
2.
seconds.
Product information
Directory for the technical after-sales
service (TK)
Production number
Production number 1
Production number 2
a The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
Cookware test
17 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
.
for 4
Display
.
.
Value
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
– Switched off.
– Switched on.
1
– switched off.
-
- minutes until the appliance switches off auto-
matically.
1
– 10 seconds
– 30 seconds
- 1 minute
– Switched off. Maximum power of the hob
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
- Not suitable.
- Not optimal.
- Suitable.
1
- Individual settings
.
- Factory settings.
Touch
to access the basic settings.
3.
and light up as a presetting.
a
Touch
repeatedly until the desired setting ap-
4.
pears.
Select the required setting in the settings area.
5.
Touch and hold
6.
a The settings are saved.
16.3 Discarding changes to the basic
settings
Touch
.
▶
a All changes are discarded and not saved.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. → Page 12
Cookware test en
1
.
1
.
for 4 seconds.
13
Advertisement
Table of Contents
