Lenovo ThinkStation P2 Tower Hardware Maintenance Manual page 94

Hide thumbs Also See for ThinkStation P2 Tower:

Table of Contents

2. Position the new heat-sink-and-fan assembly on the system board. Ensure that the four screws are

aligned with the holes in the system board. Follow the following sequence to tighten the four screws to

secure the new heat-sink-and-fan assembly to the system board. Do not over-tighten the screws. Then,

install the four screws to secure the new heat-sink-and-fan assembly to the chassis.

• Partially tighten screw

Notes:

• Apply 2.5 grams of thermal grease to the new heat-sink-and-fan assembly.

• In case you need to install the chassis beam as well, ensure that it has been installed in place before

you install the 125-watt heat-sink-and-fan assembly.

P2 Tower Hardware Maintenance Manual

, fully tighten screw

, and then fully tighten screw

Table of Contents