Troubleshooting - DeWalt DXVCS003 Instruction Manual

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
WARNING:
To reduce the chance of re
hazard, empty dust tank after each use.
BEFORE USING THIS ACCESSORY, READ
AND UNDERSTAND THE INSTRUCTION
MANUAL THAT CAME WITH THE VACUUM
The dust separator contains a lter feature. It has
the capability to inlet
can be used to inlet dust and debris out of garages
or off patios and driveways. Follow the steps below
to use the dust separator with dust tank.
1. Insert the vacuum's hose end into outlet of dust
separator, the hose should be snapped into place.
2. Locate inlet port on the dust separator.
3. Insert one end of the 1-7/8" x 7 ft. hose into the
inlet port.
4. Plug the power cord of the vacuum into an
appropriate outlet.
5. Press the switch on the vacuum to the "ON "
position.
Air Outlet
WET/DRY
VACUUM
SEPARATES & CAPTURES
UP TO
99.5%
of debris in the airstream
EMPTY THE TANK
WARNING:
To reduce the risk of injury from
accidental starting, unplug power cord before
emptying the dust tank.
1. Remove the dust separator assembly of dust
tank by pulling outward on the lid clips located
on each side of the dust tank. Lift off the dust
separator assembly assembly.
2. Dump the tank contents into the proper waste
disposal container.
sawdust and other debris. It
Air Inlet
CLEANING
To keep the poly tank looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
STORAGE
Before storing the poly tank, the dust tank
should be emptied and cleaned. The hose
may be wrapped around the lid.

TROUBLESHOOTING

NOTICE:
Minor problems often can be
xed without calling customer service.
PROBLEM
Dust separates not
separating well.
Low air volume.
Material swirls in
cyclone and won't
drop down into
drum.
Hose connections
not tight.
3
ENGLISH
SOLUTION
Air leak. Check cyclone
ange / drum lid / barrel.
Even small leaks will affect
performance.
Vacuum lter clogged.
Blockage in hose.
Air leak in bottom of cyclone
/ drum lid or dust drum.
Temporarily cut off air ow to
allow the materials to drop
into the tank and then
restart.
Use only D WALT
E
recommended ttings.