Table of Contents
Advertisement
DIN Front-mount
Installation with the rubber bush
1.Dashboard
2.Holder
After inserting the holder into the dash-
board, select the appropriate tabs accord-
ing to the thickness of the dashboard mate-
rial and bend them inwards to secure the
holder in place.
3.Rubber bush
4.Screw
1.Frame
2.Insert the release pin into the hole in the
bottom of the frame and pull out to remove
the frame.
(When reattaching the frame, point the side
with a groove downwards and attach it.)
3.Lever
insert the levers supplied with the unit into
the grooves at both sides of the unit as
shown in figure until they click. Pulling the
levers makes it possible to remove the unit
from the dashboard.
oe
kw
Advertisement
Table of Contents
