Maintenance; Protecting The Environment - DeWalt D25981 Original Instructions Manual

English
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.

WARNING:
• Be aware of the location of pipework and wiring.
• Apply a pressure of approximately 20–30 kg to the
tool. Excessive force does not speed up chiselling but
decreases tool performance and may shorten tool life.
Proper Hand Position (Fig. A, B)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on each side handle
Switching On and Off (Fig. A)
To run the tool, press the on/off switch
To stop the tool, release the switch.
Demolition, Chasing and Channelling (Fig. A–F)
1. Select the appropriate chisel and clean its shank.
2. Insert the chisel and check whether it is properly locked.
3. Hold the tool using both handles
now runs in continuous operation.

MAINTENANCE

Your D WALT power tool has been designed to operate
E
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals
may weaken the materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any
liquid get inside the tool; never immerse any part of the tool
into a liquid.
10
2 .
.
1
2 and turn on. The tool
Optional Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce
the risk of injury, only D
should be used with this product.

WARNING: These chisels can be reground only a limited
number of times. If in doubt, contact your dealer for
recommendations.

WARNING: Ensure that the cutting edge does not show
discolouration caused by too much pressure. This may
impair the hardness of the accessory.
Accessory Maintenance
Accessory maintenance at the right time guarantees optimal
results in application and a long and efficient accessory life.
Grind the chisels on grinding discs. Refer to figure G for the
appropriate angles of the following chisels:
spade-shaped chisel
14
cold chisel
15
pointed chisel
16
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
WALT recommended accessories
E