Epson C31C522111 User Manual page 16

English
Processing Checks
The TM-J9000/J9100 is capable of performing the following four actions
on a check in a single pass: reading magnetic characters, scanning the
image of both the face and the back, and printing a transaction record.
Flow of Single Pass Processing
1. Insert a check into the feeder section.
2. The printer reads the magnetic characters on the check.
3. The scanner scans the images of the face and back.
4. The validation section prints the transaction record, and the check is
fed to the outlet.
Notes on Processing Checks
❏ Do not use checks smaller than 152 × 68 mm {5.98 × 2.68 in} (W × H).
❏ Do not use checks larger than 230 × 100 mm {9.06 × 3.94 in} (W × H).
❏ Do not use copy paper or other multi-ply paper.
❏ Make sure that the checks have no curl, bending (especially on the
corners), warpage, or wrinkles.
❏ Do not use checks with paper clips, staples, adhesive tape, or other
foreign materials attached.
❏ Do not open the covers while printing and processing are in progress.
Notes on Using the Image Scanner
The printer uses the image scanner to read checks. Be sure to use a USB
interface because the image scanner requires it. If you are using an
optional UB series interface, no image data can be obtained.
Inserting Checks
With the Non-Auto Sheet Feeder (Non-ASF) Model
1. Wait until the VALIDATION/FEEDER LED starts flashing. Then, insert
the check straight with its face (the side on which magnetic characters
are printed) facing the front of the printer, continuously touching the
feeder guide with the bottom of the check until it stops as shown in
the picture below.
2. When the check is pulled into the printer, release it immediately.
14 TM-J9000/J9100 User's Manual
➀
➁