Table of Contents
Advertisement
Figure 10
2015 model shown
1. Stabilizer bracket
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as shown
in
Figure
11. Secure the pivot frame to the machine
frame using 2 bolts (5/16 x 1 inch) and 2 locknuts
(5/16 inch).
Figure 11
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
3. Secure the pivot frame to the bottom of the machine
frame using 2 self-tapping screws (5/16 x 3/4 inch) as
shown in
Figure
12.
g030494
3. Locknut (5/16 inch)
4. Bolt (5/16 x 2-1/2 inch)
5. Pivot frame
1. Self-tapping screw (5/16 x
3/4 inch)
4. Attach the draw bar decal 1.3 cm (1/2 inch) to the left
of the attachment mount
1. Draw bar decal
5. Install the bent, flared end of a rod into the keyed slot
in the left side of the machine frame, and move the rod
rearward to seat it in the frame
Note: Repeat this step for the right side of the
machine.
8
Figure 12
2. Pivot frame
(Figure
13).
Figure 13
(Figure
14).
Advertisement
Table of Contents
