Related Manuals for Bosch LM Series
Summary of Contents for Bosch LM Series
- Page 1 LM Series Horizontal Configurability LM024 | LM036 | LM048 | LMO60 | LM070 Installation Manual...
-
Page 2: Table Of Contents
LM Series Hz Configurability CONTENTS To avoid equipment damage, DO NOT use these units as a source of heating or cooling Standard Package Contents ..........3 during the construction process. Doing so Horizontal Units ..............4 may affect the unit’s warranty. The Required Tools ............ -
Page 3: Standard Package Contents
LM Series Hz Standard Package Contents | 3 STANDARD PACKAGE CONTENTS Please see Spare Parts List for Kit Assembly #’s. End Blow Unit TO Straight Through Straight Through TO End Blow Unit Straight Through End Panel End Panel Straight Through... -
Page 4: Horizontal Units
4 | Horizontal Units LM Series Hz Configurability HORIZONTAL UNITS If unit is equipped with optional Electric The Horizontal Configured water source heat Heat and Blower, overall unit wiring will pump is designed to have a field configurable need to be reconfigured for single power blower orientation: end blow (default) and straight connection. - Page 5 LM Series Hz Horizontal Units | 5 3. Remove and retain bracket by removing (3) 6. Rotate the blower into its new screws. (Figure #5) position.(Figure#8) Figure # 5 Figure # 8 4. Loosen blower assembly by removing (4) 7. Remove and retain remaining bracket by screws.
- Page 6 6 | Horizontal Units LM Series Hz Configurability 9. Remove and discard blower collar by removing 12. Reinstall bracket removed in step (#3) using (8) screws. (Figure #11) (3) screws in the same location. (Figure#14) Figure # 11 10. Reorient the blower assembly 180 degree with Figure # 14 blower “belly”...
-
Page 7: Instructions - Right-Hand Unit: End Blow And Straight Through (Lm0**-Hz-*R*-**)
LM Series Hz Horizontal Units | 7 Instructions - Right-Hand Unit: End Blow Air coil is in close proximity to the blower. and Straight Through (LM0**-HZ-*R*-**) Air coil fins are easily damaged. Great care 1. Remove and retain end and side must be taken during this step to avoid coil panels.(Figure#17) - Page 8 8 | Horizontal Units LM Series Hz Configurability 6. Remove and discard horizontal blower bracket Unit top is notched to allow blower to slide by removing (3) screws. (Figure #22) through. Figure # 22 7. Rotate the blower into its new position.(Figure#23)
- Page 9 LM Series Hz Horizontal Units | 9 11. Reorient the blower assembly 180 degree with 14. Secure (2) the now horizontal blower brackets blower “belly” up. (Figure #27) to the unit base using (4) screws. (Figure#30) Figure # 27 Figure # 30 12.
-
Page 10: Notes
10 | Notes LM Series Hz Configurability NOTES 8 733 911 121 Revised 07-13 Subject to change without prior notice LM Series Hz Configurability... - Page 11 LM Series Hz | 11 Revised 07-13 8 733 911 121 (2013/7)
- Page 12 601 N.W. 65th Court, Ft. Lauderdale, FL 33309 Phone: 866-642-3198 | Fax: 954-776-5529 www.boschtaxcredit.com | www.bosch-climate.us Revised 07-13...