Advertisement
4) POWER STANDBY/ON
switch/indicator
This is the switch for electric power.
ON.... When set to the ON position, power is supplied and the unit
becomes operational.
STANDBY .... When set to the STANDBY position, the main power
flow is cut and the unit is no longer fully operational. A minute flow
of power feeds the unit to maintain operation readiness.
The indicator above the switch lights when the power is STANDBY,
and goes out during ON.
@ Remote sensor
@LSS SET button
Use to operate the Listening Style Selector memory.
@LSS MODE button
Use to call the Listening Style Selector.
© Display section
®
This shows the position of the listening style selector.
This lights when you play a CD.
© This lights when you can select CD and DAT direct mode.
© DIRECT MODE button
Use this when you want by-pass sound quality adjustment circuitry and
listen to a CD or DAT in the direct mode.
@MUTING button/indicator
Use when you want to temporarily cut sound during playback. Press
again to return to the previous volume level.
VOLUME control
@ PHONES jack
For stereo headphones.
NOTE;
:
There is no output from the speakers when headphones are plugged
into PHONES jack.
@ Input selector buttons/indicators
[PHONO]
Press to play records on a turntable connected to the PHONO input
jacks.
{TUNER]
Press to listen to radio broadcast.
[TAPE]
Press to listen to cassette tape.
[DAT]
Press to listen to a DAT playing on a digital audio tape deck connected
to the DAT jacks.
(CD)
Press to listen to compact disc.
[LD]
Press to play an LD on a video disc player connected to the LD input
jacks.
IVCR]
Press to play a tape on a video cassette recorder connected to the VCR
jacks.
@ MIC (microphone) jack
This is a standard jack for connecting a microphone.
NOTE:
Microphone mixing is not possible when CD DIRECT or DAT DIRECT
are ON.
@ MIC LEVEL control
Used for adjusting the volume of microphone.
@3 BALANCE control
Used for changing the balance between left and right channels, Usually
sets this control to the center position.
'
(@ SPEAKERS button (A/ B OR A + B)/indicator
When the SPEAKER MODE selector switch on the rear panel is set to
the A/B (left), use this button to switch between sound from speakers
A only, and sound from speakers B only.
When the SPEAKER MODE selector switch is set to the A/A + B (right),
use this button to switch between sound from speakers A only, and
sound from both speakers A and B.
Refer to page 20 No.(S) concerning SPEAKER MODE selector switch.
SPEAKER MODE switch
indicator off
Indicator lit
|
AIB
A
B
|
AIA + B
A
A+B
NOTE:
If speakers A and B are not both connected, there will be no sound when
the button is set for A + 8.
62
Advertisement
