Table of Contents
Advertisement
c.
If any power supply units are installed in the chassis, remove them (see
power supply" on page
Step 2.
Loosen the captive screws on the front of the chassis.
Step 3.
Carefully pull the chassis out of the rack; then, remove the chassis from the rails.
Figure 13. Chassis removal
Step 4.
Carefully lay the chassis on a flat, static-protective surface.
After this task is completed
1. To remove the rails from the rack, follow the instructions below:
26).
"Remove a hot-swap
.
Chapter 4
Hardware replacement procedures
21
Advertisement
Table of Contents
