Storing The Accessories - LG VDS-ST9 Series Owner's Manual

Auto empty charging station

Hide thumbs

Table Of Contents

Table of Contents

en-us_main.book.book Page 12 Wednesday, July 12, 2023 4:56 PM

12 INSTALLATION

Before moving the product to its final

position, mark the location on the wall where

you will attach the anti-tip cord. If you are not

drilling into a wall stud, you will need to use

the wall mounting anchor.

• Install the wall mounting anchor and the

mounting band directly behind the product.

2" (5 cm)

Attach one of the mounting bands to the loop

at one end of the cord.

If drilling into drywall, use a 4 mm bit to drill a

hole 1 3/4" (44.5 mm) deep at the marked

location and insert the wall mounting anchor

first. Then screw the mounting band into the

anchor with the wall mounting screw. When

screwing into a wall stud or concrete, use the

wall mounting screw without the anchor.

Thread the other end of the cord through the

slide as shown to form a loop. Attach the

second mounting band to this loop.

Use the product mounting screw to attach the

mounting band to the back of the product.

Place the product in its final location and use

the slider to adjust the length of the cord until

there is about 1 inch of play in the cord.

CAUTION

• Do not tighten the wall mounting screw

excessively. Doing so may cause the wall

mounting to come loose and the product to fall,

resulting in personal injury or product damage.

• For best results, attach the mounting band to a

wall stud or a solid wall. If the screw pulls out of

the wall and the product falls, personal injury or

product damage may result.

• If the distance between the wall and the product

is too great, the product may fall.