Bosch AMAX panel 2100 Installation Manual page 148

148 en | Troubleshooting
No communication with the printer available, if the printer is enabled and the DX4010 is in a
normal condition.
Restore:
4
Supervise:
1.
2.
P
Printer Fault
Condition:
The printer condition is abnormal (e.g. printer no paper/printer buffer is overflow/...) if printer
is enabled and the DX4010 is in a normal condition.
Restore:
4
Supervise:
1.
2.
P
–
RF Receiver 1 Fault
Condition:
The receiver condition is abnormal (e.g. RF micro is removed/hold RF micro in reset/...) if a
wireless module is enabled.
Restore:
4
Supervise:
1.
2.
P
RF Receiver 1 Missing
Condition:
1.
2.
Restore:
4
Supervise:
1.
2.
P
RF Receiver 1 Jammed
Condition:
A signal is disturbing the receiver if a wireless module is enabled.
2015.05 | 06 | F.01U.309.277
All manuals and user guides at all-guides.com
Restore the communication with the printer to a normal condition and reset the fault.
Report the printer missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Restore the printer to a normal condition and reset the fault.
Report the printer error to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
RF Receiver Failure
Restore the communication with the receiver to a normal condition and reset the fault.
For more information, refer to RF Devices, page 83.
Report the receiver fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
No communication with receiver available if a wireless module is enabled.
A RF zone, repeater or keyfob is configured, but the wireless module is disabled.
Restore the communication with the receiver to a normal condition, enable the wireless
module and reset the fault. For more information, refer to RF Devices, page 83.
Report the receiver missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off when there is no other system fault.
Installation Manual
AMAX panel
Bosch Sicherheitssysteme GmbH