Toro 161-4519 Installation Instructions Manual

42in recycler kit

Download this manual

42in Recycler Kit

TimeCutter® 4275 Riding Mower

Model No. 161-4519

Installation

Preparing the Machine

1. Park the machine on a level surface.

2. Disengage the blade-control switch.

3. Move the motion-control levers outward to the

4. Engage the parking brake.

5. Shut off the machine and remove the key.

6. Wait for all moving parts to stop.

7. Allow machine components to cool.

8. Remove the battery packs from the machine.

9. For easier access, raise the front of the machine and support it using jackstands rated

for your machine.

Mechanical or hydraulic jacks may fail to support the machine and cause serious

injury.

Use jack stands when supporting the machine.

Preparing the Mower Deck

Remove the nuts and bolts in the holes for the kickers. Retain these for later installation.

Company

8111 Lyndale Ave So

Bloomington, MN 55044

WARNING

Installation Instructions

position.

NEUTRAL

Original Instructions (EN)

Printed in the USA

3465-258A

*3465-258* A

Page 1 3465-258A 42in Recycler Kit TimeCutter® 4275 Riding Mower Model No. 161-4519 Installation Instructions Installation Preparing the Machine 1. Park the machine on a level surface. 2. Disengage the blade-control switch. 3. Move the motion-control levers outward to the position. NEUTRAL 4.
Page 2: Installing The Kit
Installing the Kit Parts Required Baffle assembly Flange nut (5/16 inch) Carriage bolt (5/16 x 3/4 inch) 1. Install the baffle assembly to the right side of the mower deck with 2 flange nuts (5/16 inch) as shown. G463233 2. Secure the left side of the baffle to the deck using 1 carriage bolt (5/16 x 3/4 inch) and 1 flange nut (5/16 inch) as shown.
Page 3 Installing the Decal and Kickers Parts Required Decal Kicker 1. Install the decal to the mower deck as shown. G463353 6 cm (2.36 inches) 7.25 cm (2.84 inches) 2. Install the kickers into the deck with the previously removed hardware. G465615 3465-258A Page 3...
Page 4: Operation
Operation Operating Tips Using the High Blade Speed Setting For best mowing and maximum air circulation, operate the blades at the position. Air is HIGH required to thoroughly cut grass clippings, so do not set the height of cut so low as to totally surround the mower in uncut grass.
Page 5 File down any nicks and sharpen the blades as necessary. If a blade is damaged or worn, replace it immediately with a genuine Toro replacement blade. 3465-258A Page 5...
Page 6 Notes:...
Page 7 Notes:...