Adjusting the Throttle
1.
Move the throttle lever forward to the front of
the control panel slot and then move it back
approximately 3 mm (1/8 inch) into the F
position.
2.
Check the position of the speed control lever
on the fuel-injection pump. The speed-control
lever should contact the high-speed screw when
the throttle-control lever is in the F
position
(Figure
34).
Figure 34
1. Throttle cable
2. High-speed screw
3.
If necessary, adjust the position of the jam
nuts on the throttle-control cable until the
speed-control lever contacts the high-speed
screw when the throttle-control lever is in the
F
(detent) position
AST
4.
Ensure that the cable jam nuts are fully tightened
after the adjustment.
idle
AST
(detent)
AST
g248469
3. Speed-control lever
4. Jam nuts
(Figure
34).
Fuel System
Maintenance
Note:
Refer to
Fuel Specification (page 21)
proper fuel recommendations.
DANGER
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A
fire or explosion from fuel can burn you and
others and can cause property damage.
• Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is off and
is cold. Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is to the
bottom of the filler neck.
• Never smoke when handling fuel and stay
away from an open flame or where a spark
my ignite fuel fumes.
• Store fuel in a clean, safety-approved
container and keep the cap in place.
Servicing the Water
Separator
Service Interval: Before each use or daily
Every 400 hours
Service the water separator as shown in
40
for the
Figure
35.