CONTENTS Cleaning the spouts ............12 Cleaning the pre-ground coffee funnel ......12 INTRODUCTION ......... 4 Cleaning the inside of the coffee maker ......12 Symbols used in these instructions .........4 Cleaning the brewing unit ..........12 Letters in brackets ............4 Cleaning the milk container ...........13 Troubleshooting and repairs ..........4 Cleaning the coffee jug ..........14 SAFETY .............
Page 3
So whenever you use it, you can be safe in the knowledge that you’ll get great results Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and you in mind.
INTRODUCTION N.B.! Symbols used in these instructions This symbol identifies important advice or information for the Important warnings are identified by these symbols. It is vital user. to respect these warnings. Failure to observe the instructions could result in electric shock, serious injury, burns, fire or dam- Letters in brackets age to the appliance.
of children aged less than 8 years. Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction con- cerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
USING THE APPLIANCE FOR THE TURNING ON AND HEATING UP Each time the appliance is turned on, it performs an automatic FIRST TIME preheat and rinse cycle which cannot be interrupted. The appli- • Coffee has been used to factory test the appliance and it is ance is ready for use only after completion of this cycle. therefore completely normal for there to be traces of coffee in the mill.
NOTE 2: If the coffee is delivered too fast and the cream is not the appliance will display “GROUND TOO FINE ADJUST MILL AND satisfactory, see the “Adjusting the coffee mill” section. PRESS OK” and then “FILL TANK”. Check the level of water in the NOTE 3: Tips for a hotter coffee: tank and replace in the appliance.
ADJUSTING THE COFFEE MILL NOTE 5: If more than one measure of pre-ground coffee is used and the funnel clogs, push the coffee down with a knife (fig. 21) The coffee mill is preset in the factory and should not require then remove and clean the brewing unit and machine as de- adjusting.
• Fill the container with about 100 grams of milk for each You should not release the CLEAN button until the bar is cappuccino to be prepared (fig. 23). Never exceed the MAX complete indicating that cleaning is concluded. level (corresponding to about 750 ml) marked on the con- When the CLEAN button is released, the function stops.
• Press the ESC icon (B6) (fig. 18) twice to exit the menu. • Remove jug and leave the lid in the CLOSE position to keep the coffee hot. • To pour the coffee, turn the lid anticlockwise until the arrow MAKING A NUMBER OF CUPS OF is lined up with the spout of the jug. COFFEE WITH THE JUG FUNCTION Important! When the coffee beans are insufficient to (IF PROVIDED) complete the required function, the appliance stops the process Using this function you can automatically make a number of and waits for the bean container to be filled again and the cups of coffee (4, 6) directly in the jug (A9) to keep the coffee hot.
• When the bar indicates the quantity of coffee required, To remove the tray: press the OK icon (B9) to confirm. 1. Open the service door (fig. 16). 2. Remove the drip tray and the waste coffee container (fig. • To change the quantity of cups, press the icons (B7) 17).
Cleaning the milk container 4. Press the two red release buttons inwards and at the same time pull the brewing unit outwards (fig. 31). Important! Always clean the tubes inside the milk Important! Do not use washing up liquid to clean the container (C) when you prepare milk.
Cleaning the coffee jug (if provided) Rinsing Clean the jug with a damp cloth and mild washing up liquid. This function enables you to obtain hotter coffee. Proceed as follows: N.B.: To avoid damaging the appearance of the jug, do •...
incides with the number of red squares on the test strip (for Press the icon (B2) to enter the menu and then the example, if there are 3 red squares on the test strip, select icons (B7) and (B8) until “START TIME” is displayed. the message “WATER HARDNESS 3”...
bottle into the tank respecting the instructions given on the Press the OK icon (B9). descaler pack, then add water. • Press the icons (B7) and (B8) to verify: Position a container with a capacity of about 2 litres under • How many coffees and cappuccinos have been made.
od, place the main switch on the back of the appliance in the 0 position (A23). TECHNICAL SPECIFICATION Voltage: 220-240 V~ 50/60 Hz max. 10A Absorbed power: 1350 W Pressure: 15 bars Water tank capacity: 1.8 litres Size LxHxD: 594x 455x398 mm Weight: 26 kg The appliance complies with the following EC directives: •...
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL TANK! The water tank is empty or positioned Fill the tank with water and/or insert it correctly, incorrectly. pushing it as far as it will go. GROUND TOO FINE ADJUST MILL AND The grinding is too fine and the coffee Turn the grinding adjustment knob one click alternating with PRESS OK...
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Custo- mer Services. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot The cups were not preheated. Warm the cups by rinsing them with hot water.
Page 20
PROBLEM POSSIBLE CAUSE REMEDY The milk does not come out of the milk The intake tube is not inserted or is inser- Insert the intake tube (C4) in the rubber spout (C5). ted incorrectly. washer in the milk container lid (fig. 24). The milk is not well frothed.
INSTALLATION Verify the minimum measurements required for correct installa- tion of the appliance. The coffee maker must be installed in a column and the column must be firmly fixed to the wall with commercially available brackets. Important! • all installation or maintenance operations must be per- formed with the appliance disconnected from the mains electricity supply.
Page 22
x 16 x 16 x 16 Position the rails on the sides of the cabinet as shown in the figure. Position the appliance on the rails, making sure the pins are Fix with the screws, then extract them completely. correctly inserted in the housings, then fix it with the screws If the coffee maker is installed over a warmer drawer, use the top supplied.
In the user manual and on our web site, www.electrolux.co.uk you will find some useful information on how to deal with minor faults and how to take care of your product.
Page 24
Instructions User manual: English Notice d’utilisation: Français Benutzerinformation: Deutsch Gebruiksaanwijzing: Nederlands 000000000-R-WWYYYY 5713224301 /11.14...