Styling Nozzle; Paddle Brush; Cleaning - Silvercrest SRWB 1000 A1 Operating Instructions Manual

Styling nozzle

You can dry your hair with the styling nozzle 0 to prepare it for further styling,
e.g. with the round brush 8/9.
1) Attach the styling nozzle 0 to the appliance.
2) Plug the power plug into the mains socket.
3) Set the speed/temperature level "I" or "II" according to your hair type.
4) Aim the airflow at the hair and move the appliance around the head with
one hand. Run your free hand through your hair and divide it into strands.
This makes it easier to dry the parts underneath.
5) Switch off the appliance by moving the level switch 3 back to "O".

Paddle brush

With the paddle brush q, you can dry and straighten your hair at the same time.
1) Attach the paddle brush q to the appliance.
2) Plug the power plug into the mains socket.
3) Set the speed/temperature level "I" or "II" according to your hair type.
4) Place the paddle brush q at the roots and pull it down to the ends of the
hair, as with a conventional brush.
Note: You can achieve more volume by brushing the hair upside down
afterwards.
5) Switch off the appliance by moving the level switch 3 back to "O".

Cleaning

DANGER! Risk of fatal injury from electrocution! Before cleaning the
appliance, disconnect the power plug from the mains power socket!
Never immerse the appliance, the mains cable or the plug in water or any
other liquids!
After cleaning, ensure that the appliance is completely dry before using it
again!
CAUTION! Allow the appliance to cool down before cleaning it. Risk of
burns!
ATTENTION! Do not use abrasive or caustic cleaning agents. They can
corrode the surface and damage the appliance beyond repair.
Remove hair from the attachments 8–q with your fingers. Place the
■
attachments 8–q in lukewarm water to clean them. You can use mild
detergents, but make sure to rinse it off thoroughly afterwards with water.
Allow the attachments 8–q to dry completely before re-attaching them to
the appliance.
■ 10 │ GB │ IE
SRWB 1000 A1