Kenwood SS-992 Instruction Manual page 6

System connections
Make connections as shown below. When connecting the related system components, refer also to the instruction
manuals of the related components.
Do not plug in the power lead until all connections are completed.
@ Connection with KA-892 or KC-992
DO 83 cooeesm os O
Front speaker
Center speaker
SYSTEM
Australia Other countries
Audio cords =
Rear speaker
A)
AC outlet
U.S.A and Canada
Rear speaker
(L)
(Except for some areas)
System control connection
Xx
@ Be sure to insert the system control cord plugs fully into the
SYSTEM CONTROL terminals.
@ If the system contro! cord and audio cords are not connected
properly, the automatic system governing remote contro! and
system functions will not operate.
Preparations for operation A:
When this unit is connected to the TAPE 2/ADAPTOR jacks of the amplifier KA-892 or KC-992
® Set the switch on the amplifier rear @ Turn the powers of @ Press the TAPE 2/ADAPTOR key on the amplifier
panelto ADAPTOR. (The switch posi- the components to front panel so that [ADAPTOR | lights up.
tion should be changed while the ON.
power is OFF.) TAPE 2/
ADAPTOR
waar
TAPE 2 [ ADAPTOR
@ The VOLUME CONTROL of the amplifier is set automatically to the center position in about 20 seconds. The keys are invalid in this period.
@ The overall volume is to be adjusted with the VOLUME CONTROL of this unit or with the remote contro! provided with the amplifier.
@ When this unit is not to be used, press the TAPE 2/ADAPTOR key on the amplifier front panel so that | ADAPTOR |goes out.
Notes:
1. Connectall cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging connection
cords without removal of the power cord can cause malfunctions or damage to the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
6 ss-992 ¢n)