Additional Safety Warnings; Fcc Caution; Industry Canada - Bosch GRG18V-3600C Operating/Safety Instructions Manual

Safety Rules for Cordless Rivet Tool
explode, catch fire and cause personal
injury.
q. Do not damage the coin cell and or
take the coin cell apart. The coin cell
may leak, explode, catch fire and cause
personal injury.
GFCI and personal protection devices like
electrician's rubber gloves and footwear
will further enhance your personal safety.
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be care-
ful not to disassemble any portion of the
The manufacturer is not responsible for
radio interference caused by unauthorized
modifications to this equipment. Such modi-
fications could void the user's authority to
operate the equipment. This device complies
with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful inter-
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment generates uses and
can radiate radio frequency energy and, if
not installed and used in accordance with
the instructions, may cause harmful inter-
ference to radio communications. However,
there is no guarantee that interference will
This device contains
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Devel-
opment Canada's licence-exempt RSS(s).
Operation is subject to the following two
conditions:
160992A8AK GRG18V-3600C 20230616.indd 6 160992A8AK GRG18V-3600C 20230616.indd 6

Additional Safety Warnings

FCC Caution

Industry Canada

licence-exempt
-6-
r. Do not allow damaged coin cells to
come into contact with water. Leaking
lithium may mix with water to create
hydrogen, which could cause a fire, an
explosion, or personal injury.
tool since internal wires may be misplaced
or pinched or safety guard return springs
may be improperly mounted. Certain clean-
ing agents such as gasoline, carbon tetra-
chloride, ammonia, etc. may damage plastic
parts.
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to try to cor-
rect the interference by one or more of the
following measures:
• Reorient or relocate the receiving an-
tenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
(1) this device may not cause interference,
and
(2) this device must accept any interference,
including interference that may cause unde-
sired operation of the device.
6/16/2023 7:50:09 PM 6/16/2023 7:50:09 PM