Board Settings - Bosch APC-AMC2-4R4CF Installation Manual

64 en | Installing
Address
3
4
5
6
7
8
Tab. 4.8: Setting the address via the DIL switch
Mode
ON
OFF
Tab. 4.9: Protocol and connection settings
Instructions for DIL switch 5
Set SDEB (= DIL switch 5 to ON) in the following cases
–
–
Set BPA (= DIL switch 5 to OFF) in the case of an
–
Notice!
Changing the type of the host connection requires a reset of the AMC2 - see Resetting the
Software, page 94.
–
Set BPA (= DIL switch 5 to OFF) in the case of an
–
Notice!
Changing the type of the host connection requires a reset of the AMC2 - see Resetting the
Software, page 94.
4.11.3

Board Settings

The address of the board is set using a switch on the board's underside (see Equipment
Configuration, page 16). The AMC2-4R4 is always assigned address 0.
The extension boards are assigned the addresses 1 to 3.
2020-01 | V02 |
DIL Switches
1 2
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
DIL Switches
5 6
SDEB RS-485
BPA Ethernet
Ethernet host connection
RS-485 host connection, provided only one AMC2 is connected on the bus
RS-485 host connection with more than one and maximum eight AMC2s per bus
RS-232 host connection
RS-485 host connection with more than one and maximum eight AMC2s per bus
3 4
OFF OFF
ON OFF
ON OFF
ON OFF
ON OFF
OFF ON
Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.