Advertisement
ares
|
SPECIFIC SERVICE INSTRUCTIONS
M@ REMOVING
THE MAIN
BOARD
1.
As shown
in Fig. 2, slide and pull out the board in the
direction of arrow. (If necessary, take off the wire clamp and
connectors. )
*
When conducting a check with power supplied, be sure to
confirm that the CRT
earth wire is connected to the CRT
socket board and the MAIN board.
Mi SETTING UP CHASSIS FOR CHEK/REPAIR
1.
As shown in Fig.3,set the removed chassis upright.
*
When conducting a check with power supplied, be sure to
confirm that the CRT earth wire is connected to the CRT
socket board and the chassis..
Mi WIRE CLAMPING AND CABLE TIES
1.
Be sure to clamp the wire.
2.
Never remove the cable tie used for tying the wires togeth-
er.Should
it be inadvertently removed,
be sure to tie the
wires with a new cable tie: -
re
18 (No.50360)
Advertisement
