Bosch FR5CPCCF Manual page 17

CC-DA/ESR1
Minimum reflection
vertical tilt coefficient
<-15 dB
>8° <-10 dB
>18° <-6 dB
Table: minimum vertical tilt angle of fascia to sensor normal
Curvature of fascia for FR5CP
Curvature of the fascia may influence the radar performance, especially with low vertical tilt
angles. The minimum radius of the curvature shall be according to the following rules:
R > 350 mm, no significant influence expected
R < 350 mm, significant influence possible, has to be evaluated
R < 200 mm, significant influence expected, not recommended
Absorber around the sensor
It is highly recommended to use a cone made of absorber material around the radar cone of the
sensor to prevent ghost targets. The design of the absorber cone must fulfill the following
design guidelines (reflection from outside the radar cone, multipath reflection).
Reflection from outside the radar cone
Reflections from structures located outside the radar cone have to be avoided.
Furthermore interference signals picked up by the sensor antennas should be avoided by
keeping a minimum distance (d) of 5 mm to 10 mm for parts in front of the sensor.
Even with compliance to the radar cone, reflections at parts outside the radar cone may disturb
the received signal. Reflections at parts causing an interference signal to the receiving antenna
and reflections at parts getting to the receiving antenna after a second reflection at the fascia
(multipath reflection).
© All rights reserved, Robert Bosch GmbH, also for the case of protected rights applications every power of disposal, like copy-right
and passing on rights, with us. The valid issue of this template is filed in CC-DA process landscape.
Installation and Manual Documentation
FR5CPCCF
max. tolerance
tolerance ε
thickness
±0.1 mm ±0.02
±0.2 mm ±0.02
±0.1 mm ±0.2
±0.2 mm ±0.2
tanδ
r
<0.01
<0.03
<0.03
<0.05
Document date:
08 Aug 2019
application
unpainted,
(black)
painting,
embleme
unpainted,
(black)
painting,
embleme
painted
bumper
painted
bumper
Page: 17