8
Installing the Cutting Units
1. Slide a thrust washer
pivot rod.
2. Slide the cutting-unit-carrier frame
pivot rod and secure it with a lynch pin
Note:
washer between the rear of the carrier frame
and the lynch pin.
3. Grease all lift arm and carrier frame pivot
points.
Ensure that the hoses are free of twists or sharp bends and that the rear cutting unit
hoses are routed as shown. Raise the cutting units and shift them to the left (Model
03171). The rear cutting unit hoses must not contact the traction cable bracket.
Reposition the fittings and/or hoses if necessary.
4. Route a tipper chain
the end of each carrier frame. Secure the
tipper chain to the top of the carrier frame with
a bolt, a washer, and a locknut.
Setup: Installing the Cutting Units
onto each lift-arm
On rear cutting units, position the thrust
up through the slot on
onto the
.
G402579
IMPORTANT
G402580
G402581
Page 3–11
3466-297 A