• Dual remote control switch (Set J)
According to the number of connecting wired remote controller(s), turn "ON" or "OFF" the
switch 2 of DIP switch 1 on the slave remote controller.
Master controller
Slave controller
When two wired remote controllers are connected in a remote-control group, turn the switch 2
of DIP switch 1 on the slave remote controller "ON".
When only one wired remote controller is connected in a remote-control group, turn the switch
2 of DIP switch 1 on the slave remote controller "OFF".
NOTES:
• Timer setting is not available on the slave remote controller.
• Last command takes priority.
• Signal amplifier address (Set K)
1-3. Manual address setting method
2 wired remote controllers are
connected in a remote-control group
Master
OFF
ON
- (07-14) -
Only 1 wired remote controller is
connected in a remote-control group
Slave
Switch 2 of DIP switch1
Signal amplifier
(Max. 8)
Master
OFF
—
1
2
3
1. System settings