Sealey SCR02B Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. Safety
warning! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this seat.
‰
warning! Use the seat on level and solid ground, preferably concrete.
‰
locate seat in a suitable working area.
9
Keep the seat clean and tidy in accordance with good workshop practice.
9
do not use the seat for any purpose other than that for which it is designed.
8
do not stand on the seat.
8
do not use the seat outdoors.
8
do not get the seat wet or use in damp or wet locations or areas where there is condensation.
8
do not clean the seat with any solvents which may damage the paint surface or the protective coating on the padded seat.
8
do not exceed maximum capacity of 150kg.
8
2. introduction
Four legged heavy-duty steel construction with a black powder coat finish for corrosion resistance. Strengthening ring and mesh insert for
stability, also acts as a foot rest. Ø410mm Swivel seat features pneumatic height adjustment (510 to 650mm), rotates fully through 360° and is
padded with back rest for extra comfort.
3. SPecification
model no.: ............................................................... Scr02b
Capacity ....................................................................... 150kg
Height(s) ............................................................. 510-650mm
4. aSSembly
4.1. Unpack all parts before disposing of packaging material according to local
recycling regulations.
4.2. Invert frame and fit the castors to the leg bases. Note the location of the two
locking castors (fig.1).
4.3. Insert gas strut into base frame
4.4.
Place seat onto gas strut.
5. oPeration
5.1. Once the stool is assembled, compress the height adjustment lever whilst the seat is unloaded. This will allow the seat to reach its
maximum height.
5.2. To adjust the height, pull the lever slowly whilst sitting on the seat. Release the lever when at the desired height.
6. maintenance
6.1. If in constant use, check the tightness of all fixings on a weekly basis.
6.2.
The castor wheels are maintenance free; ensure they are always able to rotate and swivel freely.
6.3. Clean the seat cushion and trays with a moist cloth and mild detergent.
© Jack Sealey Limited
Pneumatic creePer Stool with
adjuStable height Swivel Seat & back
reSt
Scr02b
Model no:
Original Language Version
fig.1
SCR02B Issue 1 04/12/19