Toro 30602 Operator's Manual page 35

Select the Proper Height-of-Cut Setting
to Suit Conditions
Remove approximately 25 mm (1 inch) or no more than 1/3
of the grass blade when cutting. In exceptionally lush and
dense grass, you may have to raise the height-of-cut to the
next setting.
Mow at Proper Intervals
Under most normal conditions you will need to mow
approximately every 4-5 days. But remember, grass grows at
different rates at different times. This means that in order to
maintain the same height-of-cut, which is a good practice,
you will need to cut more frequently in early spring; as the
grass growth rate slows in mid summer, cut only every 8-10
days. If you are unable to mow for an extended period due
to weather conditions or other reasons, mow first with the
height-of-cut at a high level; then mow again 2-3 days later
with a lower height setting.
Transporting
Use the transport latches when transporting over long
distances, rough terrain, or when trailering.
After Operating
To ensure optimum performance, clean the underside of the
mower housing after each use. If residue is allowed to build
up in the mower housing, cutting performance will decrease.
Also, remove any debris which may have collected between
the deck lift cylinders and the foam deck pads (Figure 35).
Figure 35
1. Deck lift cylinder
Cutting Unit Pitch
A blade pitch of 8 to 11 mm (5/16 to 7/16 inch) is
recommended. A pitch larger than 8 to 11 mm (5/16 to 7/16
inch) will result in less power required, larger clippings, and
a poorer quality of cut. A pitch less than 8 to 11 mm (5/16
to 7/16 inch) will result in more power required, smaller
clippings and a better quality of cut.
2. Foam deck pad
Maximizing Air Conditioner
Performance
•
To limit solar heating, park the machine in a shaded area
or leave the doors open in direct sun.
•
Check to make sure the air conditioning condenser fins
are clean.
•
Operate the air conditioner blower at the mid speed
setting.
•
Verify continuous seal between the roof and the headliner.
Correct as required.
•
Measure the air temperature at the front center vent in
the headliner (Typically stabilize at less than or equal to
50 degrees F.)
•
Refer to the Service Manual for additional information
35