BACK COVER OPTIONAL ACCESSORIES Warranty card attached Thank you very much for purchasing this Panasonic product. Please read these operating instructions carefully before operation and maintenance. Also, be sure to read the “SAFETY PRECAUTIONS” section (P.2 ~ 4) before use.
SAFETY PRECAUTIONS Please strictly follow Disconnect power supply before maintenance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervi- sion or instruction concerning use of the product by a person responsible for the safety.
Page 3
SAFETY PRECAUTIONS Please strictly follow WARNING Do not disassemble or modify Clean the power plug the product. regularly. (Otherwise, the product may catch (If dust is found on the power plug, fire or malfunction, thus resulting in insulation maybe damaged by humidity fire or electric shock.) and fire may occur.) Contact the dealer for repair.
SAFETY PRECAUTIONS Please strictly follow CAUTION Do not clean the product with Do not sit on or lean against gasoline or other volatile mix- this product. ture solvents, and avoid con- (Otherwise, the product may fall over and injury may occur or damage the tacting with spray insecticides.
All of the above features have been tested by SGS-CSTC Standards Technical Services Co., Ltd. Note: nanoe and the nanoe mark are trademarks of Panasonic Holdings Corporation. nanoe X are particulate ions containing hydroxyl radicals whose amount is 10 times that of nanoe...
MAIN PARTS IDENTIFICATION Front Back Control panel Air outlet (nanoe X emission outlet) Clean sign Odor sensor Louver Handle (left and right) Air inlet (both sides) Front panel Power cord Air inlet (front) Power plug Dirt sensor Clean sign Dirt sensor and Odor sensor Show the air pollution levels detected by dirt sensor and odor sensor.
SETUP Before startup Install filters Fill in the label Remove the deodorizing filter with the first from the poly bag. date of use. Remove the front panel. Front panel Pull it forward with both hands Toggle the filter hook upward, and remove filters (2 types).
Page 8
SETUP Install filters Power-on Connect the Install the filters (2 types) and front power plug. panel. Install deodorizing filter. Toggle the filter hook downward, (There is no distinction and secure filters. between inside and outside, Filter hook upper and lower) Down Deodorizing filter When inserting the power...
OPERATION Timer button/indicator Econavi button/indicator PM2.5 button/ Air volume button/ Power Off/On Child lock button/ indicator indicator button indicator Power Off/On Turn on or off the product. Press the button to operate. The product operates in auto air volume mode when it is used for the first time, then operates in the last mode when it was stopped.
Page 10
OPERATION PM2.5 Remove PM2.5 quickly. When indicator is on, you can press the button to remove PM2.5 quickly, until the indicator lights off. (At this moment the PM2.5 mode will stop, then product will switch to the previous mode and continue.) But, If you press the button when indicator is off, the PM2.5 mode only will operate in 1 min, then product will switch to the previous mode and continue.
MAINTENANCE Notice WARNING For installation and removal methods of front panel and filters, please read P.7 ~ 8. Make sure to disconnect the When cleaning, do not leave the removed parts unattended. power plug before cleaning (Otherwise, it may cause tripping or damage.) the product.
MAINTENANCE Filter replacement (Optional accessories: back cover) HEPA composite filter Deodorizing filter When the filter replacement indicator lights Replacement Filter replacement period may be ※ period on. (About once every 10 years) ※ shorten, depending on the environ- ment (such as where smoking is When the product inhales the smoke of six frequent).
Page 13
FURTHER INFORMATION About HEPA composite filter The HEPA composite filter which with the Bio-sterilization and Super Allergy-buster can inhibit allergens (pollen, dead mites and feces), bacteria, mold. Super Allergy-buster: inhibits the activity of allergic substances (pollen, dead mites and feces). Testing authority: Osaka Municipal Technical Research Institute Test method: check the decrease of refined house dust mite allergen, by using enzyme immune measuring method.
Page 14
FURTHER INFORMATION Type of airflow The louver move to the best position according to the air quality to clean the air. Clean sign Action of louver Figure Air quality Air is clean Blue Switch direction Odor, PM2.5 or smog is Upward detected Front...
Please confirm the following before you put questions forward or send the product for repair. Why does the clean sign turn off Why is a “jee” sound from the during operation? emission outlet? There is a slight sound when nanoe X is The product detects the indoor brightness, being generated.