Operating The Appliance; Cleaning And Maintenance - Bosch DFS097K50 Instructions For Installation And Use Manual

Operating the appliance

en
1Operating the appliance
These instructions apply to several appliance variants. It
p l i a n c e O p e r a t i n g t h e a p
is possible that individual features are described which
do not apply to your appliance.
Control panel model 1
Explanation
Fan on/off
#
1-3 Fan settings
Intensive setting 1
C
Intensive setting 2
D
Fan run-on
%
Metal grease filter saturation indicator
E
Light on/off/dimming
B
Setting the fan
Switching on
Pull out the filter pull-out and touch the
■
The fan will start at setting 2.
Select the fan settings.
■
When the filter pull-out is pushed in, only fan
Note:
settings 1, 2 and 3 can be selected.
Switching off
Touch the symbol. Slide in the filter pull-out.
%
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the or
C
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the symbol for the required fan setting.
Fan run-on time
Touch the y symbol or slide in the filter pull-out while
the extractor hood is operating.
After approximately 10 minutes, the fan will switch off
automatically.
6
% symbol.
symbol.
D
Switch on the extractor hood when you start
Note:
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Saturation display
When the metal grease filters are saturated, an audible
signal sounds for approximately four seconds after the
fan is switched off.
The indicator above the
If you have not yet done so, the metal grease filters
should now be cleaned.
For instructions on how to clean the metal grease filters,
please refer to the section:
The saturation indicator can be reset while it is flashing.
To do this, touch the
E
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the symbol.
B
Setting the brightness
Press and hold the symbol until the required
B
brightness is reached.
Audible signal
Switching on the audible signal
Touch and hold the
#
same time for approximately three seconds when the
fan is switched off. An audible signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
symbol flashes as well.
E

Cleaning and maintenance

symbol.
and symbols at the
C
.