Handle; Grip - Bosch JLR-100-069 Original Instructions Manual

en-gb | 35 | JLR-100-069
6.1

Handle

Figure 37: Replacing the Handle
1 Handle
7 Bottom Frame
25 Hexagon Head Screws M8 x 45 8.8 (4 pieces)
1. Remove the hexagon head screws (25) from the
handle (1) and set them aside.
2. Pull the handle (1) out of the bottom frame (7)
and dispose of it.
3. Push the new handle (1) in the bottom frame (7)
so that the holes in the frame (7) align with the
holes in the handle (1).
4. Tighten all four hexagon head screws (25) in the
holes with a torque of 25 Nm.
SP04006297 | 06/2021
6.2

Grip

Figure 38: Grip
4 Platform (extendible)
28 Grip
1. Loosen both M6 screws and washers on the grip
(28) and set it aside. Remove the grip (28) from
the extendible platform (4) and dispose of it.
2. Attach the new grip (28) to the extendible
platform (4) and secure it with both M6 screws
and washers. Tighten the M6 screws with a
torque of 11 Nm.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany