Panasonic ER-CTB1 - Electric Toothbrush Manual
Parts Identification (Fig. 1)
- Head
- Multi-fit brush
- Protective cap
- Extra-fine brush
- Protective cap
How to use
- Mount the head to the main body until it clicks.
- Mount the brush to the head. 3 Place the brush in your mouth, turn on the power.
- The use time after a full charge is as follows.
ER-CBL1: 110 minutes
ER-CBN1: 70 minutes
(Use time may vary depending on ambient temperature and use conditions.)
Removing and mounting the head (Fig. 2)
Remove the head while pushing the head release button ().
- Stand the head when it is removed.
Mount the head to the main body until it clicks.
Removing and mounting the brush (Fig. 3)
Rotate the brush in the direction of the arrow to remove or mount it.
- Pulling the brush while it is fastened may damage the head or the main body.
- When toothpaste gets hard and makes it diffi cult to remove the head, put it in water or warm water for a while and then remove.
Note
- The brush should be replaced with a new one every 3 months or so due to hygiene reasons, even if its shape is unchanged.
How to clean (Fig. 4)
- Make sure that the main body is turned off.
- After cleaning, store the brush with the protective cap attached.
- Remove the head and brush.
- Rinse them with running water.
- Thoroughly rinse the inner and bottom of brush.
- Wipe off the water with a dry cloth and dry it well.
Replacement parts
Replacement part is available at your dealer or Service Centre.
Multi-fit brush | ER-6CT01 |
Extra-fine brush | ER-6CT02 |
Specifications
Airborne Acoustical Noise |
53 (dB (A) re 1 pW) |
This product is intended for household use only.
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Panasonic ER-CTB1 - Electric Toothbrush Manual
Need Assistance?
Do you have a question about the ER-CTB1 that isn't answered in the manual? Leave your question here.