Modifiers - Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual

During the washing phase, the drum
rotates in opposite directions at 40 rpm
repeatedly. Spin speed reaches 1100
rpm for both intermediate and final spin
to reduce the remaining moisture
content and chemical residues
contained in the loads as well as
optimize the rinsing efficiency.
Additional options can be selected for
this program such as Rinse plus",
Bleach", and Heavy duty". All these
options can be selected individually or
simultaneously.
Selecting Rinse plus" will add an
additional rinse to the program to better
remove chemical residue.
Selecting Bleach" option will ensure
bleach dispensation at the right time.
The dynamic load sensor will add
enough water to dilute the bleach,
preventing bleach marks on the
clothes.
Heavy duty" option will extend the
wash phase to a longer period of time
to achieve optimum wash performance
(see detailed explanation of heavy
duty).
Rinse and Spin
Program for rinsing unsoiled textiles,
e.g. swimwear, and for removing
detergent residue from textiles. Ends
with a spin cycle.
Spin
Spin cycle for spinning wet, hand
washed laundry.
Water is drained before and during the
spin cycle.
Drain
Can be used to drain water without a
spin cycle.
Temperature Settings
The following wash temperatures are
available:
XXTRASANITARY170 °F (77 °C)
Temp. boost: 150 °F (66 °C)
(only Regular/Cotton)
hot: 125 °F (52 °C)-
warm: 95 °F (35 °C)
cold: 60 °F (15 °C)
All manuals and user guides at all-guides.com
Maximum spin speeds of the
programs
The indicator light max spin speed" is lit red.
Revolutions Program
per minute
1100 Regular/Cotton
800 Permanent Press
600 Delicates/Silk
800 Wool
1000 Qucik Wash 25
1100 Spin
1100 Rinse and Spin
1100 XXtra Sanitary
Reduced spin
The indicator light reduced spin" is lit red.
Only if you have selected a reduced
spin speed for gentle treatment of your
laundry.
Gentle spin speeds
The indicator light Gentle spin speed" is lit
red.
Revolutions Program
per minute
400 Hand Wash
No final spin
The indicator light no final spin" is lit
red.
For delicate laundry, the water remains
in the machine after the last rinse.
Use this setting to avoid creasing if the
clothing cannot be taken out of the
washing machine immediately upon
completion of the cycle.
CAUTION
Before unloading you must drain the
remaining water by selecting Drain
or Spin and starting the machine.

Modifiers

Spin Selection
Preset cycle setting of max. spin speed
can be reduced.
Press this button until the desired
setting is indicated.
Delay Start
Before starting a program you can
modify when the cycle should be
started.
Press Delay Start button. The display
shows the start time
0:00.
The time can be delayed up to a
maximum of 19 hours (with 1 hour
increments) by pressing the
button repeatedly.
The Start time begins running
immediately after pushing the
Start/Pause button. This is indicated
by the points between the digits
flashing.
i Changes to the Start time are
possible at any time, press the
Delay Start button until the new
time appears.
i If the program is changed or if the
program is interrupted, the
preselected Start time is also
interrupted. The Ready in time of
the program is displayed. The
Start time must be reselected.
Delay Start
17