Husqvarna AUTOMOWER 430X Operator's Manual page 31

In settings you can change the general settings
to your product.
3.10.8.1 Profiles
Different sets of product settings can be saved if
the product is used in different work areas with
different charging stations. You can set a
maximum of 3 profiles.
To save settings to a profile
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use > Profile A, B or C .
3. Select a profile and push the OK button.
Save and push the OK button.
4. Select
Note: If the settings that are not stored to the
profile are made, the symbol * is shown beside
the profile name.
To use a profile
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use > Profile A, B or C > Select.
3.10.8.2 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
ECO mode .
3. Push the OK button to select
1201 - 001 - 05.06.2019
3.10.8.3 Spiral Cutting
The product cuts the grass in a spiral pattern if
the grass is longer in an area.
be set in 5 levels:
• Low-
• Low
• Mid
• High
• High+
The level sets how sensitive the product is to
changes in grass height.
Settings >
Note:
area mode. Cutting in the
does not let the product to start
Spiral Cutting does not start in slopes steeper
than 15%.
To set the level of Spiral Cutting
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Spiral Cutting > Use > Intensity .
3. Use the arrow buttons to select the level of
Settings >
Spiral Cutting .
3.10.8.4 Slope Control
The Slope Control function decreases lawn wear
in slopes.
settings.
To enable or disable the Slope control
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Slope control > Use .
3.10.8.5 General
In General you can change the general settings
of the product.
To set the time & date
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
Settings >
move through the menu structure
General > Time & Date .
ECO mode .
Spiral cutting can
Spiral cutting is only started in the Main
Secondary area mode
To get access to the menu
Slope Control is enabled in the factory
To get access to the menu
To get access to the menu
Spiral cutting .
Settings >
Settings >
Settings >
Installation - 31