Cleaning the PM1.0 Sensor
The PM1.0 (super ultra-fine dust) sensor is
the device detecting fine dust and large dust
contamination levels, so it is recommended to
clean the lens periodically, at least once every 2
months.
Based on the front of the product, hold and
1
gently pull both sides of the air inlet (cover)
to separate it.
• The side with the LG logo at the center
of the product is the front of the product.
Cover
Push the sensor cover up.
2
3
Put a little water on a cotton swab to wipe
the lens, and wipe away any remaining
moisture with a dry cotton swab.
Close the sensor cover.
4
NOTE
• Do not wipe the sensor with anything
wet other than something that has been
dampened using only water.
– Doing so may cause product failure.
• When opening or closing the sensor cover, a
sound may be heard as a result of friction.
MAINTENANCE
27
EN