Table of Contents
Advertisement
Function
1. Power switch
Controls input power supply.
*If the power switch trips out automatically, do not turn it back on .Contact manufacturer's agent.
2. Gas check switch
Set this switch at "Weld" when performing normal welding ,set it at "Check" when adjusting the flow of
argon gas.
3. Crater control switch
Crater "ON", "OFF" and "repeat" are controlled by this switch at TIG welding.
4. Power lamp
Turn on when the power switch is "ON".
5. Torch select switch
Cooling type, water cooling or AIR, is selected according to the torch in use.
6. Cooling water & Temperature warning lamp
Function
6
Advertisement
Table of Contents
