Adjust The Column Tilt; Before Drilling; Drill Motor Spacer Block; Recommended Drill Diameter - Husqvarna DS900 Operator's Manual

Adjust the column tilt

The drill column can be tilted, recommended range in use
is 0-60°.
• Loosen the locking screw for column tilt and set the
desired drill angle. Tighten the locking screw.
• The angle indicator can be used for approximate
adjustment. If higher precision is required, alternative
measuring methods should be used.
10 – English
OPERATING

Before drilling

!
!

Drill motor spacer block

(accessory)
A spacer is used in order to drill large diameters. There
are several different versions.
• Assemble the spacer on the drill motor
• Then assemble the drill motor with spacer onto the
stand, see section 'Assembly of drill motor'.

Recommended drill diameter

Max. drill bit diameter, inches/mm
Drill motor
DM406
DM650
DM280/340 370/14,6 470/18,5 570/22,4 670/26,4

When drilling

NOTICE! Make sure the cable and/or water hose is not
pinched between the guide wheel and the column.
WARNING! Before drilling, check that all
locking screws are tightened well.
Serious accidents can occur if the
concrete core remains in the drill when
backing out the drill motor/drill from the
floor, wall or ceiling.
WARNING! When drilling ceilings, always
use a water collector that is approved for
your drill motor, or use a hydraulic drill
motor. There is a risk that the drilling
machine and the stand become live if
water leaks into the machine.
Spacer, inch/mm
0 50/2
19,7/500 600/23,6 700/27,6 900/35,4
400/15,7 19,7/500 600/23,6 800/31,5
2x 50/2 200/7,9