3.3.10.
IOREAD [ON | OFF]
Enable/Disable I/O addressing
When the TRACE command is executed some addresses and values are displayed next to the
disassembled instructions. This can be completely disabled for I/O-instructions (transfer, bit,
e.g. MOVX I:10,A), if the OFF option is selected. However, accessing via other instruction
(e.g. physical address) does not avoid to read the I/O-register.
Default setting is ON.
>ioread off↵
... Disables address checking for I/O instructions.
3.3.11.
EMULATION [ON | OFF]
Specify ANSI emulation features.
Some terminal programs are able to decode special escape sequences which change the actual
colour or result in other screen manipulations. The monitor can be configured to generate such
sequences to print its output messages using different colours and to clear the terminal window
on certain points. The current mode is displayed, if no option is specified.
>emulation on↵
... Enables the monitor to use ANSI-sequences.
Note:
These terminal emulation functions are not supported by ProMan !
3.3.12.
CLS
Clear Screen
The CLS command will print the ´Clear Screen´ escape sequence if ANSI functions are enabled
(see EMULATION).
3.3.13.
COLORSET [ O
Select Monitor colour set
One of four various colour sets can be set here. They are called as their background colour.
Without parameter the current mode can be displayed.
Power On default is BLACK.
Options:
BLACK, BLUE, GREY, CYAN.
>colorset cyan↵
... Changes to cyan background colour.
- 22 -
FUJITSU MB90675-Evaluation Board - User Manual
PTION
]
© FUJITSU Mikroelektronik GmbH 1996