Adjusting The Anti-Scalp Rollers; Adjusting The Skid - Toro Groundsmaster 3200 Series Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers
1. Park the machine on a level surface, lower the
cutting unit, engage the parking brake, shut off
the engine, and remove the key.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
12.
Note:
Select a hole so the anti-scalp roller
is positioned to the nearest corresponding
height-of-cut desired.
Figure 12
Front rollers shown
1. Anti-scalp roller
2. Bushing
(Figure 11).
Figure 11
3. Flange nut
4. Bolt

Adjusting the Skid

Mount the skid in the lower position when operating in
height of cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height of cuts
lower than 64 mm (2-1/2 inches).
1. Park the machine on a level surface, lower the
cutting unit, engage the parking brake, shut off
the engine, and remove the key.
2. Remove the flange-head bolts and nuts from the
skid.
3. Move the skid to the desired position and secure
it to the cutting unit with the flange-head bolts
and nuts
g297467
1. Flange-head bolt
2. Skid
Figure
g296902
14
(Figure 13).
Figure 13
3. Nut
g295676