Page 9
* at the operator’s ear 6 . Do not force the tool. nOTE (D27300 OnLY): This device is intended for the connection to a power supply system ʵ It will do the job better and safer at the rate to which it was intended.
Page 10
EngLIsH ʵ Watch what you are doing. Use common sense. Do not operate the tool when you are • Health hazards caused by breathing dust developed when planing wood, especially oak, tired or under the influence of drugs or alcohol. beech and MDF. 20 .
Page 11
31 to each of the upper legs 32 using a hex head bolt 17 Your D WALT D27300 Planer and Thicknesser have been designed for professional cutting Belleville washer 23 and nut 18 (Fig. E3). of hard and soft wood. It performs planing and thicknessing operations easily, accurately 5.
Page 12
EngLIsH nOTE: If using a dust extractor, lower the upper table all the way and attach the adapter to the No-volt Release Function dust chute, then raise the upper table until is in contact with the adapter. Should the power be shut off for some reason, the switch has to be deliberately reactivated. Adjustment Motor Overload Protection Device In case of motor overload, the power supply to the motor will be cut off.
EngLIsH MAINTENANCE Protecting the Environment Your D WALT power tool has been designed to operate over a long period of time with a Separate collection. Products and batteries marked with this symbol must not be minimum of maintenance. Continuous satisfactory operation depends upon proper tool care disposed of with normal household waste.