Panasonic FP7 Series User Manual page 47

(Note 1) The layout of the operation monitor LEDs on Ver. 1 of the CPU unit is different from that on Ver. 2 or
later.
(2) Extension cassette (optional)
Attach an optional extension cassette (communication cassette or function cassette).
(3) COM0 port terminal
Three-wire RS-232C port.
(4) GT power supply terminal
For our programmable display "GT series", either 5V DC output or 24V DC output can be used.
(3)(4)Terminal layout
• AFP7CPS4R*
• AFP7CPS3R*
COM.0 port
GT power
supply
output port
(Note 1) Each terminal of the COM.0 port is insulated from the internal circuit. Also, theSG terminal (COM.0
port) is insulated from the 0V terminal (Power supply output for GT).
Power supply connector
Used for connecting to an external power supply (24 V DC). When a power supply unit is used,
do not connect this.
(6) DIN hook
Used for fixing the unit on the DIN rail.
(7) LAN port (CPS4RE, CPS4RES, CPS3RE, CPS3RES)
Port for connection to Ethernet LAN
(8) USB port
Used for connecting with a PC on which tool software is used.
(9) Unit connector
Used for connecting an I/O unit or intelligent unit. An end unit is fitted when the unit is shipped.
(10) Dip switch (CPS4RE, CPS4RES)
Do not change the setting. The switches are all set to OFF at the factory.
(11) Card cover
WUME-FP7CPUH-09
2.1 CPU Unit (CPS4R*/CPS3R*)
2-3