Assembly - Bosch BDU336Y Owner's Manual

Fitting and removing the display
(see figure A)
A
(1)
1
(4) (8)
1
(8)
To fit the display (1), attach the display (1) to the
front edge of the display fixture (8) in the direction of
travel, on the latching hook (4) ❶ and press the rear
side of the display (1) on the display fixture (8) ❷.
To remove the display (1), pull the display (1) to-
wards you ❶ until you are able to lift off the dis-
play (1) ❷.
A retaining strap can be secured to the bridge (10).
Note: The eBike system switches off if you are travel-
ing slower than 1.9 mph and take the on-board com-
puter out of the holder. This does not apply to eBikes
with a support up to 28 mph.
Bosch eBike Systems

Assembly

2
(10)
(1)
2
Inserting the Locking Plate (see figure B)
B
(5)
Note: Depending on the design/installation of the dis-
play mount, it may be the case that the removal
blocker cannot be used. The display must be installed
here.
Insert the locking plate (3) into the adapter shell (5)
from below until you hear the locking plate (3) click
into place.
From this point onwards, you can no longer lift off the
display (1) from the display fixture (8) without re-
moving the display fixture (8) from the adapter
shell (5) by loosening the two fastening screws (9).
Note: The locking plate (3) is not an anti-theft device.
English – 9
(8)
(9)
(3)
0 275 U07 3BK | (04.03.2022)