Table of Contents
Advertisement
Connections (Continued)
HD Monitor Component (YPbPr) Connections
Antenna
Connect the "Antenna/Cable" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 10.)
Connect the "ANT LOOP OUT" jack from the HDTV Receiver to the "Antenna In" jack on your TV using a coaxi-
2 2
al RF cable.
Connect the "COMPONENT OUT" jacks from the HDTV Receiver to the "COMPONENT IN" jacks on your TV
3 3
using RCA-type cables. (The Output Selection must be set to YPbPr, refer to Display Format Setup on page
17.)
Connect the L/R "AUDIO OUT" jacks from the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using
4 4
RCA-type cables.
ote
1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.
12
Cable TV
ANTENNA
Wall Jack Panel
INPUT
OR
HD Ready TV Connection Panel
AUDIO INPUT
COMPONENT VIDEO INPUT
Pr
Pb
Y
L
R
HDTV Receiver Connection Panel
VIDEO
INPUT
To AUDIO OUT
Advertisement
Table of Contents
