Storing The Chiller / Installing Anti-Vibration - LG ACHH017VBAB Installation And Owner's Manual

STORING THE CHILLER / INSTALLING ANTI-
Storing the Chiller
If the chiller must be stored at the construction site before installation / operation,
on the chiller until ready for installation.
Installation Considerations
• As soon as the chiller is delivered, check for any damages. If there are damages, immediately contact the shipping company; make nota-
tions on the shipping documentation when signing for the load.
• Install in a location where it is flat and there is enough strength to support the weight of and vibration from the chiller.
• Install in an area that allows for optimum airflow at both inlet and outlet sides; enough space for wiring, and piping; and is easily accessible
for installation, inspection, maintenance, and service. See the specification table, dimensions, and wiring diagram for clearance require-
ments, net weight, etc.
• Inspect the field-installed base, and resolve any issues before installing the chiller.
• Install the chiller so that it will not fall over due to strong winds or earthquakes.
• If installing the chiller in a coastal area where it is impacted by ocean winds, additional anti-corrosive treatment must be applied to the
condenser.
• If combining multiple chillers, it is best to ensure all are at the same level so that the water pipes can be easily connected.
WARNING
Improper installation will cause the unit to fall over, resulting in physical injury or death.
Improper installation can cause product malfunction and damage.
Installing Anti-Vibration
• Use field-supplied anti-vibration and install before placing the chiller on the base or its installation area.
• Anti-vibration is required and is to be specified and selected properly based on weight and local wind code
requirements. All fasteners to be properly specified by a professional.
• See image for guidance on where to install the anti-vibration on the chiller.
• Anti-vibration is required and is to be specified and selected properly based on weight and local wind code
requirements. All fasteners are to be properly specified by a professional.
Figure 26: Location of Anti-Vibration.
(765)
1 UNIT
(765) (765)
2 UNIT
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
do not allow dirt or moisture. Place a protective cover
Unit:mm
(765) (765) (765)
3 UNIT
VIBRATION
Anti
-vibration
pad
33