DeWalt 49A70003038 Operator's Manual page 9

Triple Bagger Usage
NOTE:
When all grass bags are full, place the tractor on a firm, level surface, disengage the PTO, turn
the tractor engine off and set the parking brake.
1. Open hood by pushing in on the rear, right-side tab with your right hand (1),
and lifting the cover with your left hand in the center rear of the bagger
cover (2) as shown in Figure 22.
2. Do not remove the hose assembly from the tractor.
3. Remove the three bag assemblies from the bag support brackets by lifting
the front edge up first, and then sliding the back edge out and up until it is
clear of the frame. See Figure 23.
4. Empty grass clippings at a proper disposal site, use the handle at the bottom
of each grass bag. Holding the bag firmly, empty the contents.
5. Replace grass bags, close lid, restart your tractor, release parking brake and
resume cutting your grass.
Figure 22
OPERATION
Figure 23
9