Pioneer VREC-130RS Owner's Manual page 8

Precautions before connecting the system
WARNING
• Firmly install this product so it does not fall off the windshield. If this product is not firmly installed,
it may fall off the windshield while driving and cause an accident. Periodically inspect this product.
• Pioneer recommends that only authorized service company personnel, who have special training and
experience in mobile electronics, set up and install this product.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.
• It is extremely dangerous to allow cables to become wound around the steering column or shift
lever. Be sure to install this product, its cables, and wiring away in such so that they will not
obstruct or hinder driving.
• Make sure that the cables and wires will not interfere with or become caught in any of the
vehicle's moving parts, especially the steering wheel, shift lever, parking brake, sliding seat
tracks, doors, or any of the vehicle's controls.
• Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires
may become damaged, resulting in a short circuit or malfunction and permanent damage to the
product.
• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may
fail to work properly.
• Never feed power to other electronic products by cutting the insulation of the power supply cable of
this product and tapping into the cable. The current capacity of the cable will be exceeded, causing
overheating.
To prevent damage
WARNING
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product.
− 8 −