Page 1
INSTRUCTION MANUAL MANUEL D'INSTRUCTION MANUAL DE INSTRUCCIONES Cordless Inflator Gonfleur sans fil Inflador Inalámbrico DMP181 IMPORTANT: Read Before Using. IMPORTANT : Lire avant usage. IMPORTANTE: Lea antes de usar.
ENGLISH (Original instructions) SPECIFICATIONS Model: DMP181 Overall length with BL1815N 297 mm (11-3/4″) with BL1860B 316 mm (12-1/2″) Maximum air pressure 1,100 kPa (160 PSI) Duty cycle 10 minutes On / 5 minutes Off Rated voltage D.C. 18 V Net weight 2.4 - 2.8 kg (5.3 - 6.2 lbs)
Page 3
Personal Safety Maintain power tools and accessories. Check for misalignment or binding of moving parts, break- Stay alert, watch what you are doing and use age of parts and any other condition that may common sense when operating a power tool. affect the power tool’s operation.
Page 4
21. Do not disassemble the tool. 22. Use only standard accessories provided When inflating objects, connect the air chuck, by Makita. The use of any other accessories adapter, and valve tightly. Otherwise, the object, or attachments might present a risk of injury to hose, air chuck, or adapter may be damaged and persons.
It will To install the battery cartridge, align the tongue on the also void the Makita warranty for the Makita tool and battery cartridge with the groove in the housing and slip charger.
Page 6
Tool / battery protection system CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen. If not, The tool is equipped with a tool/battery protection sys- it may accidentally fall out of the tool, causing injury to tem.
Page 7
Switch action Target pressure value Pressure value unit WARNING: If the object to be inflated is connected to the tool, the Before installing the battery car- current pressure value of the object is displayed on the tridge into the tool, always check to see that the pressure gauge when you turn on the tool.
Page 8
Lighting up the front lamp Storing hose When you turn on the tool by pressing the main power The hose can be attached to the hose holder of the tool. switch, the lamp lights up. When you turn off the tool by pressing the main power switch, the lamp goes out.
Attach the Presta valve adapter to the valve OPERATION stem, and then attach the air chuck to the Presta valve adapter. NOTE: The standard adapters vary depending on the country. Using the Schrader valve adapter Attach the air chuck to the valve stem. ►...
Inflate the floating tube by pulling the switch trig- repairs, any other maintenance or adjustment should ger while checking the status of the floating tube. be performed by Makita Authorized or Factory Service NOTICE: Centers, always using Makita replacement parts.