Selecting The Heater; Setting The Cooking Level With And Without Heat Boost - Sharp KH-3V19NT00-EU User Manual

Turn the Appliance off and on
If the appliance is in standby mode,
it is put in operating mode by holding
the On/Off button
1 second. A buzzer signal acoustically
indicates the successful operation. A
´0` appears and all decimal points on
the heater flash (1 sec on, 1 sec off) on
all the heaters.
If operation does not start within 10
sec, the display for all heaters will turn
off.
If the displays are turned off, the heater
will be go into standby mode.
If is pressed more than 2 sec (in op-
erating mode), the appliance will switch
off and is go back to the S mode. The
appliance can be turned off by pressing
at any time, even if other buttons
are pressed simultaneously.
If there is a residual heat from a heater,
this will be indicated on the heater
display.

Selecting the Heater

If a single heater is chosen by press-
ing the respective activate/deactivate
heater button, the decimal point on the
related heater display will flash. For the
selected heater, you can set the heat
level between 1-9 by touching the heat
setting buttons
The buttons must be pressed within 3
sec, otherwise the heater selection will
be erased and the heat setting dot will
disappear (decimal point). If there is
no further operation within 10 sec, the
heater goes back into the S mode.
down for at least
or .
The heat setting can always be
changed by pressing
level 1-9.
Each button operation or each dis-
play change is confirmed by a buzzer
signal.
Setting the Cooking Level With
and Without Heat Boost
All heaters are equipped with heat
boost functionality.
If the heat boost is active, then the
heater will be operated with maximum
power for the period of the heat boost
time, which is dependent on the se-
lected heat setting. This is indicated by
a flashing ´A`, alternating with the heat
setting value (e.g. 0.5 sec ´A` and 0.5
sec ´9`) on the heater display. Once
the heat boost time has ended, only
the heat setting will be indicated.
If the heat boost is used for a heater,
heater level 9 must be operated by
pressing
setting the heat to level 9 , ´A` will be
indicated alternating. This means that
level 9 and heat boost is now active.
The heat boost can be turned off by
pressing
pears.
If the heat boost is used, it can always
be activated by reactuating
heat setting is set to level 9. ´A/9` will
flash on the heat display .
EN -10-
or
starting from level 0. After
until heat setting ´0` ap-
between
it if the