•
Trap Community String: Specifies the SNMP trap community in
which you want to enable this system (e.g. lgecommunity or
public).
Output
•
Relay Off
-
ALARM ACKNOWLEDGE: Use the ALM.OFF button to stop
alarm.
-
POST-ALARM TIME: The alarm is stopped after post-alarm
time.
•
System Alarm Out: Outputs the alarm (relay) signal via the
selected alarm out terminal number when the system has some
problem. If you do not use this function, select [NONE] option.
•
HDD Fail Alarm Out: Outputs the alarm (relay) signal via the
selected alarm out terminal number when the HDD is failed. If
you do not use this function, select [NONE] option.
•
Video Loss Alarm Out: Outputs the alarm (relay) signal via the
selected alarm out terminal number when a video signal from
the camera has stopped because of a cable disconnection or
malfunction of a camera. If you do not use this function, select
[NONE] option.
Buzzer
Marks up when you want to activate the selected option.
•
Sensor: Makes a sound when a sensor occurs.
•
Motion : Makes a sound when a motion is detected.
•
Text: Makes a sound when the DVR detects text input.
•
System: Makes a sound when a cooling fan is not activated or
the HDD has bad sector.
NOTE
•
Data cannot be saved in HDD which is occurred bad sector.
But if HDD is installed more than 2 on this unit, data is saved in
other normal HDD.
•
When HDD has bad hold, can not operate normally. Replace
the HDD immediately .
Installation
43
3