Table of Contents
Advertisement
Step 2
Move the cursor to "SUPER-D5" and select the item from the following:
ON (default): Activates the SUPER-D5 function all the time. (☞ See below)
OFF: Deactivates the SUPER-D5 function. (☞ Page 11)
Note:
• When "ON" is selected for "SUPER-D5", the following settings will be restricted.
SHUTTER: Only OFF and 1/120 are available. (☞ Page 11)
SENS UP: Only "OFF" and "AUTO" become available. (☞ Page 11)
• When "ON" is selected for "SUPER-D5", a shadow (black line) may appear at the boundary between a brighter area and a darker
area. This is not a malfunction.
• When "ON" is selected for "SUPER-D5", the SUPER-D5 function will become more effective by slightly incrementing "LEVEL".
However, flickering or noise may be observed frequently when "LEVEL" is too much incremented.
• When flickering or noise is observed frequently due to the illumination of light, select "OFF".
(1) When flickering or color deterioration is observed
(2) When noise is produced in a bright area on the screen
When using the SUPER-D5 function
Follow the procedure below.
Step 1
Move the cursor to "LEVEL" and use the right or left button to adjust the level.
When not using the SUPER-D5 function
Follow the procedure below.
Step 1
When the SUPER-D5 function is set to "OFF", bright areas of an image are masked to facilitate the visibility of dark areas.
Move the cursor to "MASK SET" and press the setting button.
→ The mask setting screen appears.
"ALC CONT" screen
**ALC CONT**(1)
BACK LIGHT COMP
SUPER-D5
OFF
MASK SET
... | ... 0
LEVEL
-
MANUAL ABS
RET TOP END
Step 2
Mask bright areas.
Use the up, down, right, and left buttons to select an area to be masked and press the setting button. When the selected area is
masked, the masked area will start blinking (between stripes and white screen). When selecting another area after masking, the
masked area will be edisplayed in white. Repeat the above procedure to mask other areas as necessary.
Note:
• To cancel the masking, select the masked area to be canceled, and then press the setting button.
• To cancel all the masking, hold down the right and left buttons for more than 2 seconds simultaneously.
10
Mask setting screen
+
Area setting screen
**AREA
**(1)
POSITION
PUSH SW
UPPER LEFT
DEL
RET TOP END
Advertisement
Table of Contents
