Sharp MD-DR470HS Service Manual page 17

Continuous Playback
• Continuous playback from current pickup position
T P L A Y
PLAY
AUTO1 Practice finish ?
YES
AUTO2 Practice finish ?
YES
S Q # # # #
A P # # # #
• Continuous playback from any address
T P L A Y
DISP
A d 0 0 3 2
PLAY
S Q # # # #
A P # # # #
* When the [STOP] button is pressed in specific menu, the "TEST MODE STOP" state is set.
* In the start address set state the start address changes as follows when the [DISP] button is pressed.
0 0 3 2 (initial value)
H
A d 0 0 3 2
* In the start address setting state the start address change digit changes when the [REC] button is pressed.
1st digit (initial value)
REC
A d 0 0 5 0
* In the start address set state the value of selection digit changes in the range of "0h to Fh"
when the [SKIP UP/DOWN] button is pressed.
* If the [REC] button is pressed in the continuous playback state, the mode is changed to the B-ATT setting
state of the ATT manual adjustment.
S Q # # # #
A P # # # #
REC
H B
L B
* In the continuous playback state the number of jump lines changes as follows shown
the [Remote Controller BASS] button is pressed.
1 (initial value)
1 T R
* When the [SKIP UP] button is pressed in the continued playback mode, jump of specified
number of lines occurs in the external periphery direction.
If the key is held down jump occurs continuously. (100 ms cycle)
* When the [SKIP DOWN] button is pressed in the continuous playback mode, jump of
specified number of lines occurs in the internal periphery direction.
If the key is held down, jump occurs continuously. (100 ms cycle)
• Focus balance Adjustment mode
T-PLAY Each indication
PLAY
b # # #
MENU
Others indication
* The focus balance adjustment mode is available only for low reflection discs.
* The RANDOM marker lights up in the focus balance adjustment mode.
* The focus balance ( ) can be changed by the VOLUME UP/DOWN button operation.
* If the PLAY button is pressed in the focus balance adjustment mode, the unit returns to the
continuous playback mode.
NO
E r A D J
NO
AUTO2 Practice
YES
No error ?
NO
A D J. N G
: Continuous playback menu
: Start address setting
: Continuous playback (pit section)
: Continuous playback (groove section)
# # # # : Address
0 3 C 0
H
A d 0 3 C 0 A d 0 7 0 0
0 9 5 0
H
A d 0 9 5 0
2nd digit
REC
A d 0 0 5 0
A d 0 0 5 0
: Continuous playback (pit section)
: Continuous playback (groove section)
# # # # : Address
: High-reflection pit section
: Low-reflection groove section
: ATT setting
10
1 0 T R 1 0 0 s t p
: Continuous playback menu
: Focus balance Adjustment mode
: Focus balance
# # # : Jitter error
– 17 –
MD-DR470H/MD-DR480H
: Continuous playback menu
SQ : Continuous playback (pit section)
AP : Continuous playback (groove section)
# # # # : Address
0 7 0 0 0 8 A 0
H
A d 0 8 A 0
3rd digit
REC
B-ATT (focus) setting
B-ATT (focus) setting
100step
H