Connecting The Mediamaster; Front And Rear Panel; Preparing The Remote Control - Nokia MEDIAMASTER 110S Introduction Manual

Connecting the Mediamaster

Front and Rear panel

A constant green light indicates that the
Mediamaster is turned ON.
A constant red light indicates standby mode.
The light flashes red when commands from
the remote control are received.
The light flashes green during software
updates.
Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected; 1.0 m)
• an Introduction Guide
• a separate power supply

Preparing the remote control

• Remove the cover from the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
* The TV SCART Socket
When you connect other devices to this socket, always use a fully
connected SCART cable like the one supplied. There are SCART
cables available that do not have all the pins connected,
which could reduce picture quality if you were to use them.
GB 5
Antenna
for connection of the
satellite antenna
DC in
for connecting the cable
from the external power
supply
Slot
for a Conax smart card
Digital audio TV SCART socket *
Digital audio output for connection to the TV
(TOS-link optical
connecttion)
Power supply
Remote Control