Ethernet Host Interface - Bosch ADS-AMC2-4R4CF Installation Manual

Access Modular Controller 2
4.8

Ethernet host interface

The controller offers a 10/100 Mbit/s Ethernet auto-sensing interface to connect to a local
area network or host computer.
Notice!
i
Use a CAT5 network cable or higher version to connect the controller with the network.
Figure 4.9: Location of the Ethernet interface
Notice!
After connecting a new controller to a network using DHCP, it can take some time before the
i
new controller is recognized by the remote server.
You can accelerate this process by running the following command in a command console:
ipconfig /flushdns
This makes the controller immediately available by its name.
Notice!
When using an Ethernet connection, switches 1 and 5 of the DIP switch must be set to the
i
ON position (= factory setting) (see Figure 3.3, item 1 , page 10 ). This also ensures correct
communication with the Bosch Building Integration System (BIS) and the Bosch Access
Management System (AMS).
Notice!
i
When a controller is connected to a new switch, is powered up or detects a new network link
(after the reboot of the switch or the replacement of the cable, for example), the controller
broadcasts its presence over the network.
Bosch Security Systems B.V.
Installation manual
Installing | en 21
2022-03 | V03 |